Engine Declas - Valve cover and oil breather
Posted:
Mon Dec 27, 2010 2:58 pmby pfarber
These decals are available from Ross Prince in Australia.
Mr Prince can be reached via e-mail at:
[email protected]
Re: Engine Declas - Valve cover and oil breather
Posted:
Mon Dec 27, 2010 3:01 pmby pfarber
Before you post, YES, I KNOW that valve clearance was increased on CCKWs to .016.
If you have a copy of the decal saying such, please e-mail or post a picture.
Re: Engine Declas - Valve cover and oil breather
Posted:
Sat Jan 08, 2011 4:49 amby pfarber
The valve clearances were adjusted to
INTAKE: .012
EXHAUST: .016
Previously to December7th, 1943 both were to be set to .012. This is from GM Tech Bulletin G-86.
No information regarding the valve cover decal was altered... I would assume that they added a line to ensure the proper valve clearances were made. But so far nothing conclusive has been found.
Re: Engine Declas - Valve cover and oil breather
Posted:
Sat Jan 08, 2011 5:04 amby pfarber
This is an interesting picture taken from GM Tech. Bulletin G-97 covering the reworking of exhaust manifolds. The valve cover decals are that the REAR:
Most Tm pictures put the decals at the FRONT: